idp SMART Series User Manual page 57

IC(PC/SC) : Contact Smartcard Encoding
In SMART-31 printer, a contact smartcard encoder can be installed and SMART-31 printer
supports the contact smartcard encoder in the printer inside. "IC(PC/SC)" is to test a
contact smartcard encoding.
"ICH Contact" is to bring the encoder head into contact with the IC chip of smartcard
physically.
"ICH Discontact" is to separate the encoder head from the IC chip of smartcard physically.
"Init" is to recognize and display the installed contact smartcard reader. The recognized
encoder will be displayed at the pull down control.
"Contact" is to contact with the smartcard electrically and initialize.
"Reset" is to finish the function electrically. After "Contact", you can run "Get ATR", "Read",
"Write" and "Clear".
"Get ATR" is to read the ATR data.
"Read" and "Write" are to read and write the defined data (Name, Address and Phone).
These could not be applied to all cards.
"Clear" is to clear the displayed data (ATR, Name, Address and Phone).
In case the data is read and written using APDU, Read/Write can be done by APDU
commands.
"Load APDU" is to read the stored APDU commands.
"Save APDU" is to save the displayed APDU commands.
"Clear APDU" is to clear the APDU section.
"Send APDU" is to run the APDU commands.
Batch process repeats the following steps sequentially, Card "IN"  Move "IC"  IC "ICH
Contact"  IC "Init"  IC "Contact"  IC "Reset"  IC "ICH Dis-contact"  Card
"OUT".
57