Dräger CPS 7800 Instructions For Use Manual page 33

7.2 Preparing for storage
1. Close the fastener system up to approx. 5 cm before the
end. Regularly check whether the fastener system is still
adequately greased.
2. Pull the flat bag supplied over the hood.
3. If the chemical protective suit is folded together, pull the
supplied flat bag over the safety boots so that the chemical
protective suit is not discoloured.
7.3 Storage of the chemical protective suit
The following storage options are possible:
Lay the chemical protective suit flat during storage. If the

chemical protective suit is stored in the utility vehicle, avoid
wear due to constant friction against the storage surface.
Hang up the chemical protective suit on an appropriate

hanger or a hanging rail. The hood or protective boots must
be in contact with the ground.
Fold up the chemical protective suit and store it in a

transport case, storage bay or carrying bag.
Pack the chemical protective suit in a CPS storage and

transportation bag.
NOTICE
i i
Dräger recommends packing the chemical protective
suit in the CPS storage and transportation bag to
protect it from environmental influences and to extend
maintenance intervals.
7.3.1 Folding up the chemical protective suit
NOTICE
i i
Fold up the depressurized chemical protective suit
carefully.
Do not use force to bend the suit material, seams and
fastener system in the process. Avoid sharp bends.
1. For a permanently fitted
full face mask:
a. Pull the flat bag over
the full face mask and
the hood.
Dräger CPS 7800
2. Turn up the socks or
protective
Avoid sharp bends.
3. Place the sleeves into the
centre of the chest section.
Smooth out any creases.
4. Fold the hood and top
section of the chemical
protective suit so that they
are positioned on the
rolled up protective boots.
Smooth out any creases.
7.3.2 Packing the chemical protective suit in a CPS
storage and transportation bag
1. Place the
protective suit in the CPS
storage and transportation
bag.
2. Fix the full face mask or
face cuff using the hook-
and-loop strap.
3. Place the protective boots
as illustrated.
4. Secure the
protective suit below the
sleeves and on the boots
using straps.
5. Fold up the sleeves on the
shoulders and place on the
sides.
6. Close the CPS storage and
transportation bag.
7. Turn up the CPS storage
and transportation bag to
the middle on the tip of the
boots and directly under the
visor or on the neck, respectively.
8. Turn up the CPS storage and transportation bag in the
middle and close the strap buckles.
00821986.eps
boots twice.
chemical
chemical
Storage
00921986.eps
01021986.eps
01121986.eps
33