Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
7.
Prepare RO system for installation - continued
Fig. 7
•
Measure length of 1/4" white tubing required to
connect RO system outlet from flow restrictor to
the to the waste water adapter, as shown in Fig. 7.
•
Cut tubing length accordingly. Insert end of 1/4"
tube onto 1/4" faucet barb, making sure it covers
the barb to the top.
•
Measure length of 1/4" white tubing required to
connect base of threaded stem of faucet to the (#5)
post-carbon polishing filter outlet (#5) and cut
tube accordingly. See Fig.7.
5 Stage Reverse Osmosis System
8.
Install RO faucet - continued
Fig. 8
•
Connect this 1/4" white tube to compression filter
components as shown in Fig. 8.
•
Insert compression filter assembly into base of
threaded stem of faucet as shown in Fig.8.1 (a)
•
Take the faucet base and snake it over the tubing
and threaded stem until it sits against the bottom
of the faucet handle section. See Fig. 8.1 (b) Insert
tubing and threaded stem through drilled hole
until the faucet base is flush against the countertop
•
Assemble remaining faucet components below
the countertop. Tighten completely once faucet is
in correct position over the sink.
Fig. 8.1
a
b
9
Advertisement
Table of Contents
