Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
3.
Prepare RO system for installation
Fig. 3
COLD
•
Map out installation under the sink. Identify an
easily accessible area to mount the RO system
and determine the location for the RO storage
tank. See Fig.3.
•
Mark holes for mounting screws 10" (25.4cm)
apart center to center. The screws should be high
enough to allow 4-6" (10-15cm) clearance from
the bottom of the RO system to the floor if possible.
This is to provide space for filter changes. See Fig.
3.1
•
Hang the RO system on the mounting screws.
•
NOTE: The filters come with a protective wrap that
Fig. 3.1
4-6"(10 -15cm)
6
AquaWave
4.
Unwrap and re-install filters #1, #2, #3 into the system
Fig. 4
•
Unscrew the filter housing using the wrench
and turning it counterclockwise. See Fig.4.
•
Remove filter from housing, take off and discard
the plastic wrapping.
•
Re-install the filter into the housing and ensure the
top part of the filter fits onto the locator tab in the
housing cap.
•
Check to make sure that the O-ring is seated
correctly in the groove of the top of the sump as
otherwise leaks can occur. Screw the sump back
into the cap by turning clockwise and using the
wrench to tighten. DO NOT OVERTIGHTEN.
10" (25.4cm)
INSTALLATION MANUAL
™
Classic Reverse Osmosis System
Advertisement
Table of Contents
