Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
If inlet water pressure is over 50 psi, a pressure
regulator must be installed and set at 40 psi or less.
You must check and comply with all local plumbing
codes.
1.
Install water supply valve.
Fig. 1
•
Identify the cold water supply line under the sink
cabinet. Shut the cold-water supply valve.
•
Turn on the cold-water tap to release pressure
from the lines until water flow stops.
•
Disconnect the cold-water line from the angle stop
valve and identify if it is a 1/2" or 3/8" connection
and select appropriate water supply adaptor.
•
Assemble the 1/4" water supply valve into the
appropriate diameter water supply adaptor using
Teflon™ tape on male threads before insertion.
•
Wrap threads of water supply adaptor and angle
stop valve 2-3 times with Teflon™ tape.
•
Screw the water supply adaptor to angle stop
valve and tighten with adjustable wrench.
•
Screw the cold-water supply line to threads of
water supply adaptor and tighten with adjustable
wrench.
5 Stage Reverse Osmosis System
2.
Install waste water clip
Fig. 2
•
Identify the drain outlet location. Make sure that it
is away from the garbage disposal See Fig.2.
•
Knock out center hole on foam seal.
•
Use the hole in foam seal as a template to locate
your drilling position above the drain trap, mark
exact location with a pencil.
•
At the marked location, drill 1/4" (6.35mm) hole
through the wall of the drain-pipe. Be sure not to
penetrate opposite side of the pipe.
•
Remove protective cover from the back of foam
seal and attach it to the front plate drain connector
in alignment with drain tube hole.
•
Begin to position the drain connector on sink
drain- pipe with screws and nuts, using your
pencil in the drain connector tube hole to guide
your location over your drilled hole as you securely
tighten nuts and screws.
5
Advertisement
Table of Contents
