Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
9.
Install RO storage tank
Fig. 9
•
Wrap stainless steel thread connection on top of
storage tank with Teflon™ tape.
•
Hand-tighten the tank ball valve to the stainless
steel connection as shown in Fig. 9.
•
Place tank in vertical position in the cabinet.
•
Measure length of 1/4" white tubing from outlet of
ball valve to the inlet of the post-carbon polishing
filter as shown in Fig. 9.1.
•
Cut tube accordingly and insert one end of tube
into 1/4" compression fitting of ball valve, gently
tugging to ensure it is in place.
Fig. 9.1
10
INSTALLATION MANUAL
™
AquaWave
Classic Reverse Osmosis System
10.
Connect tubing to RO system
Fig. 10
•
Connect 1/4" white tube from outlet of flow
restrictor to drain connection on waste water clip.
•
Connect 1/4" white tube from bottom of faucet
threaded stem to outlet of post-carbon polishing
filter by unscrewing the plastic nut, inserting the
tube and screwing back finger-tight.
•
Connect 1/4" white tube from main water supply
to inlet of 1st stage (marked "IN").
•
Connect 1/4" white tube from tank ball valve to
inlet of post-carbon polishing filter.
Advertisement
Table of Contents
