Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
7.
System start-up
•
Ensure RO faucet is turned off/closed.
•
Turn on main cold water supply valve and ensure
that the 1/4" water supply valve to the RO system
is in open position.
•
Ensure ball valve on top of tank is in open position.
•
Purge air from the system by slowly opening up
faucet until water runs smoothly and then turn off.
•
Over two hours, the pressure in the RO system will
build as water flows through the system. During
this time, monitor the system for any leaks at
connections or fittings.
•
If leaks are present, fix by ensuring all tubing is cut
squarely, fully inserted and/or by adding more
wraps of Teflon™ tape. Confirm there are no
notches, scratches, or dents in any of the tubing.If
found, replace tubing, or cut approximately 1" off
from damaged area and re-assemble as length
permits.
•
If the system exhibits no leaks, then allow the
system to fill the tank.
•
DO NOT USE OR DRINK THE FIRST TANK OF RO
WATER
•
Turn off the 1/4" water supply valve.
•
Empty first tank of water by turning on the RO
faucet, letting it run until the water stops flowing.
•
Turn on the 1/4" water supply valve.
•
Allow the tank to fill a second time (approximately
1-2 hours) and then enjoy clean, great tasting
water from your new RO system!
5 Stage Reverse Osmosis System
11
Advertisement
Table of Contents
