Table of Contents
Advertisement
INTRODUCTION
Congratulations on your purchase of the AquaWave™ Classic Reverse Osmosis System.
The AquaWave Classic Reverse Osmosis System is designed with advanced filtration technology, and utilizes a 5-stage
filtration process to purify and deliver fresh tasting water. This system is designed exclusively for municipal water
systems, and will remove volatile organic chemicals, chlorine, odor, sediment, suspended impurities, metals and other
harmful contaminants from your water.
This instruction manual illustrates the AquaWave Classic Reverse Osmosis System installation and operation. Please be
sure to read the contents of this manual before installation.
The system should be installed by a qualified professional installer or licensed plumber. Installation must be in
accordance with local and state plumbing codes.
WARNINGS & PRECAUTIONS
•
WARNING: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection
before or after the system.
•
WARNING: The system may at no point be exposed to pressures above the rated pressure as this may cause system
damage!
•
WARNING: A qualified installer shall install protective devices if the system pressure may at any time exceed the rated
maximum pressure due to pressure surges or water hammer, or other excessive pressure events to ensure that the
maximum operating pressure of the system will not be exceeded!
•
CAUTION: Water pressure must not exceed 4 bar | 60 psi. Minimum water pressure should not be lower than 1.4 bar |
20 psi.
•
CAUTION: Protect system against freezing. Freezing can cause system damage and result in water leakage!
•
CAUTION: Install the system in a sheltered or covered location and protect it from excessive heat!
•
CAUTION: Do not install where the system will be exposed to direct sunlight!
•
CAUTION: The system is intended for use with tap water, and should not be installed for use with other water sources,
such as mountain spring water or groundwater.
•
CAUTION: System must be installed on the cold-water piping line. Do not install on hot water piping. Inlet water
temperature should not exceed 100°F | 38°C.
•
CAUTION: Avoid ambient temperatures over 100°F | 38°C
•
CAUTION: System contains replaceable sediment and activated carbon filters, as well as a replaceable reverse
osmosis membrane which is critical for the effective reduction of TDS (Total Dissolved Solids). Water purified by this
system should be tested periodically to confirm the system is operating properly.
•
CAUTION: Filters must be installed according to labeling and with the designated inlet water flow direction.
•
CAUTION: Pay attention to safety when drilling close to the wires and plumbing parts of the installation.
2
INTRODUCTION AND WARNINGS
™
AquaWave
Classic Reverse Osmosis System
Advertisement
Table of Contents
