Download  Print this page

Haier ES100V-G1 Instruction Manual

Home water heater.
Hide thumbs
   

Advertisement

Troubleshooting
Symptom
Things to Check
1 Whether the water supply
has stopped or whether
the water pressure is too
low
2 Whether the water-usage
point is blocked or
whether the hot water
valve is openeded
1 Whether hot water outlet
is opened
Only cold
2 Whether the water
water but the
temperature is adjusted
heating
indicator
3 Heating time is too short
lamp is lit
and set temperature is
not achieved
4 Whetehr heating pipe is
damaged
1 Whether power is
Only cold
properly connected
water and
the heating
2 Whether thermostat is
indicator
out of control
lamp is not lit
Heating
1 Water has not reached
the set temperature
indicator
light Is on all
2 Whether thermostat is
the time
out of control
Water volume
is sometimes
large or small,
Whether water pressure is
or water is
stable
sometimes
hot or cold
1 Whether the present
temperature setting is
Samll hot
too low
water outflow
volume
2 Whether water pressure
is too much
Safety Notices(Please read before use)
Meanings
of Icons
These are actions
These are actions
which must be
which are forbidden
carried out
Forbidden
Warning
Immediately cut off power supply and
contact our Service Center once the
water heater does not work properly or
emits burnt smell.
This icon is used by Haier
Water Heaters to indicate "
safety warning experts". It
indicates that the product is
equipped with special t
echnology that constantly
monitors the status of your earth line, to
ensure safety during showering.If the
icon is lit, it means that there is electricity
in the earth line. You should immediately
stop using the water heater and disconnect
the power plug. Do not touch the outer
casing of any electrical appliances in your
home. Remember to also contact the local
After-sales department or property
management company in order for them to
engage qualified electricians to carry out a
system check until the icon is no longer lit.
220V/50Hz independent power source
must be used at all times.
Warning
To ensure safety, the water heater should
be connected to independent sockets (do
not use adapters), with reliable earthing.
In addition, the power socket must conform
to national standards. Use of water heater
Earthing
without reliable earthing is strictly prohibited.
Use pen multimeter to check whether the
live line and zero line are reverse.
Do not use damaged wire and power
socket. Promptly clean the dust on the
power plug and socket.
Warning
Check the power meter and the electric
wire's diameter to ensure that they comply
with the rated current for the water heater.
Where necessary engage qualified
Warning
electrician to check the electric circuit.
Do not touch the plug with wet hands, and
make sure that the water heater, plug
socket do not come into contact with water.
If they are accidentally wet, they must be
checked by professions appointed by our
Forbidden
company before using, in order to prevent
electrocution.
Solutions
Check
Check and clear
Check and open
Increase the temperature to the required
value. Once the water is heated to the
pre-set temperature, control flow volume
of cold and hot water using the moderating
mixing valve.
Adjust water temperature
Confirm it is not due to the reasons under
,
and
, then contact Maintenance
Department
Check power socket
Confirm that this is not due to reason
,
then contact Maintenance Departmentnt
Continue heating
Confirm that this is not due to reason
,
then contact Maintenance Departmentnt
Set lower mixing valve or ensure water
pressure is stable before use
Calibrate using the method stipulated in the

Instruction Manual

Set lower mixing valve
0040503115
0040502335
V*****
V
These are matters for
which attention is
required
CAUTION
Storing of inflammable and explosive items
near the water heater is strictly prohibited.
Forbidden
Do not connect to power when installing or
repairing the water heater.
Forbidden
Non-professionals are strictly prohibited from
carrying out repairs, maintenance, dismantling
or revamping of the water heater.
Forbidden
Installation of water heater outdoors is strictly
prohibited.
Forbidden
Do not install the water heater in an environment
which is susceptible to ice-formation. Ice will
cause the container and water pipe to break,
Forbidden
leading to scalding and water leakage.
Please take precautionary measures during cold
weather, in order to prevent damage to water
heater from freezing.
Warning
If the soft power cable is damaged, it must be
replaced by professional staff from the
manufacturers or Maintenance Department in
Warning
order to avoid danger.
Take care not to be scalded by heated water.
·
Touching of hot water valve and pipes is strictly
prohibited.
CAUTION
Make sure to check the water temperature before
·
use; use only when it feels suitable.
Do not use water from the water heater for drinking
or similar purposes.
Forbidden
Please cut off the power supply if the water heater
was not used for an extended period of time. Drain
the water heater of all water according to the
instructions in the chapter on Cleaning and
CAUTION
Maintenance.
1
Haier Home Water Heater
Please read this Instruction Manual carefully before use.
Please retain this manual for future reference.
Electrical Diagram·Exterior and accessories·

Technical parameters

Electrical Diagram

L:Live wire (brown)
N:Neutral line (blue)
MT:Manual-reset thermostat
BT:Adjustable thermostat
L
HL:Heating indicator light
EH:Heating tube
N
E:Earth line (yellow-green; dual color)
Exterior and accessories
Front view
Rear view
A
B
A : Hot water outlet
B : Cold water inlet
C : Inner chamber
D : Temperature measurement pipe
E : Heating pipe
Net
a1
Capacity
Model No.
weight
(mm)
(L)
(kg)
ES50V-G1(H)
19.5
50
19.5
410
ES70V-G1(H)
70
23.5
410
ES100V-G1(H)
100
30
410
100
370
Note 1.The margin of error for the above parameters (measurements, weight) is ±10%.
2.The thermometer is not a precision instrument. It consists of three areas denoted by blue;
orange and red, which indicate the temperature of water in the inner chamber from low to
high respectively.
Technical parameters
Voltage
Rated power Rated pressure Waterproof rating
230V~,50Hz
2150W
0.80MPa
Instruction manual
ES50V-G1(H)
ES70V-G1(H)
ES100V-G1(H)
MT
BT
EH
HL
E
E
Side view
Cross-section view
F
F : Magnesium rod
G : Wall hook
b1
c1
d1
e1
f1
(mm)
(mm)
(mm)
(mm)
(mm)
420
730
100
200
320
420
935
100
200
480
420
1230
100
200
730
380
100
200
Water pressure
IPX4
Not less than 0.05MPa
2

Advertisement

   Also See for Haier ES100V-G1

   Related Manuals for Haier ES100V-G1

   Summary of Contents for Haier ES100V-G1

  • Page 1: Instruction Manual

    HL:Heating indicator light emits burnt smell. Forbidden EH:Heating tube This icon is used by Haier E:Earth line (yellow-green; dual color) Water Heaters to indicate " Do not connect to power when installing or safety warning experts". It repairing the water heater.
  • Page 2: Installation Method

    3 As long as the hot water is adequate, set a lower temperature to reduce heat loss, high ES50V-G1(H) temperature corrosion and scaling, thus extending the water heater’s lifespan. ES70V-G1(H) 4 Do not place inflammable substances such as petrol near the water heater; otherwise it may cause fire. ES100V-G1(H)

This manual also for:

Es50v-g1Es70v-g1Es50v-g1(h)Es70v-g1(h)Es100v-g1(h)

Comments to this Manuals

Symbols: 0
Latest comments: