Download Print this page
Danfoss REG 15 - 65 Instructions Manual
Danfoss REG 15 - 65 Instructions Manual

Danfoss REG 15 - 65 Instructions Manual

Advertisement

Available languages

Available languages

Quick Links

Installation
Fig. / Abb. 1
Fig. / Abb. 3
Fig. / Abb. 5
© Danfoss A/S (AC-SMC/MWA), 06-2010
Instructions
REG 15 - 65,
REG-SS 15 - 40
Fig. / Abb. 2
Fig. / Abb. 4
DKRCI.PI.KM0.A2.52 / 520H1539
Nm
LB-fod
LB-feet
LB-ft
Pieds-livres
DN 15-25
22
16
DN 25-50
44
32
DN 65
75
53
1

Advertisement

loading

Summary of Contents for Danfoss REG 15 - 65

  • Page 1 Instructions REG 15 - 65, REG-SS 15 - 40 Installation Fig. / Abb. 1 Fig. / Abb. 2 LB-fod LB-feet LB-ft Pieds-livres DN 15-25 DN 25-50 DN 65 Fig. / Abb. 3 Fig. / Abb. 4 Fig. / Abb. 5 ©...
  • Page 2 Vedligeholdelse / Maintenance / Wartung / Maintenance Fig. / Abb. 6 Fig. / Abb. 7 LB-fod LB-feet LB-ft Pieds-livres DN 15-25 DN 25-40 DN 50-65 Fig. / Abb. 8 Fig. / Abb. 9 Fig. / Abb. 10 DKRCI.PI.KM0.A2.52 / 520H1539 © Danfoss A/S (AC-SMC/MWA), 06-2010...
  • Page 3: Installation

    Udskift hele pakdåsen (fås som reservedel), når der udføres service og vedligeholdelse. Kontakt venligst Danfoss i tilfælde af tvivl. Svejsning Som hovedregel må pakdåsen ikke afmon- For at forhindre, at teflonpakningen i ven- teres, hvis der er indvendigt tryk på ventil- tilsædet og O-ringene mellem ventilhuset...
  • Page 4 Check that the cone has been fully screwed The valve must be installed with the back towards the bonnet before it is (An Allen key is included in the Danfoss spindle vertically upwards or in horizontal replaced in the valve body (fig. 4).
  • Page 5 Das Ventilgehäuse muss nach der Ausbau des Ventils empfohlen. Für weitere Informationen Installation frei von Belastungen (externen Den Ventildeckel nicht entfernen, solange wenden Sie sich bitte an Danfoss. Spannungen) sein. das Ventil unter Druck steht. - Kontrollieren, dass der O-Ring (Abb. 9, Temperaturbereich REG-Ventile dürfen nicht in Anlagen...
  • Page 6: Montage

    (une clé allen est incluse dans le jeu de à l’horizontale (figure ). Les vannes tout montage. joints d’étanchéité de Danfoss Industrial doivent être ouvertes manuellement Vérifier que le cône a bien été complète- Refrigeration).
  • Page 7 © Danfoss A/S (AC-SMC/MWA), 06-2010 DKRCI.PI.KM0.A2.52 / 520H1539...
  • Page 8 DKRCI.PI.KM0.A2.52 / 520H1539 © Danfoss A/S (AC-SMC/MWA), 06-2010...

This manual is also suitable for:

Reg-ss 15 - 40