Axis P3267-LVE User Manual page 58

AXIS P32 Dome Camera Series
Specifications
RJ45 with High Power over Ethernet (High PoE).
RJ45 Push-pull Connector (IP66) with High Power over Ethernet (High PoE).
RJ45 Ethernet service port.
D-coded M12 connector with Power over Ethernet (PoE).
SFP connector.
NOTICE NO NO TICE TICE
Use the supplied midspan.
NOTICE TICE
NO NO TICE
To comply with the IP66-rated design of the camera and maintain the IP66 protection, the supplied RJ45 Push-pull Connector
(IP66) shall be used. Alternatively, use the RJ45 IP66-rated cable with premounted connector which is available from your
Axis reseller. Do not remove the plastic network connector shield from the camera.
Audio connector
3.5 mm connector
• Audio in – 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).
• Audio in – 3.5 mm input for a digital microphone, an analog mono microphone, or a line-in mono signal (left channel is
used from a stereo signal).
• Audio in – 3.5 mm input for two mono microphones, or two line-in mono signals (using the supplied stereo-to-mono
adapter).
• Audio in – 3.5 mm input for a stereo microphone, or a line-in stereo signal.
• Audio out – 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active
speaker with a built-in amplifier. A stereo connector must be used for audio out.
• Audio out – 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active speaker
with balanced input and a built-in amplifier. A balanced connector must be used for audio out.
• Audio out – 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active speaker
with a built-in amplifier. A pair of headphones can also be attached. A stereo connector must be used for audio out.
Audio input
1 Tip
Unbalanced microphone (with or without electret
power) or line
Balanced microphone (with or without phantom power)
or line, "hot" signal
Digital signal
Stereo unbalanced microphone (with or without electret
power) or line, "left"
Audio output
2 Ring
Electret power if selected
Balanced microphone (with or without phantom
power) or line, "cold" signal
Ring power if selected
Stereo unbalanced microphone (with or without
electret power) or line, "right"
58
3 Sleeve
Ground
Ground
Ground
Ground