Table of Contents
Advertisement
Chapter 4 • Cabling and connections
32
1037751-0001 Revision A
Transmit cable
Connect the Tx cable to the radio transmitter as follows:
1. Remove power from the satellite modem.
2. Connect the Tx cable (marked with blue electrical tape) to the
CAUTION
Coaxial cables and connectors can corrode if exposed to
moisture. Use only compression type connectors, and
weatherproof them with dielectric silicone grease and
weatherproofing tape.
3. Fill the connector with dielectric silicone grease and tighten
4. If necessary, secure the cable with cable ties.
Receive cable
Connect the Rx cable to the LNB as follows:
1. Ensure that power has been removed from the satellite
2. Connect the Rx cable (marked with red electrical tape) to the
CAUTION
Coaxial cables and connectors can corrode if exposed to
moisture. Use only compression type connectors, and
weatherproof them with dielectric grease and
weatherproofing tape.
transmitter connector marked IFL, shown in Figure 25.
the cable connector to 22 in-lb with a torque wrench.
Figure 25: Transmit connector
modem.
receive connector on the LNB, shown in Figure 26.
Advertisement
Table of Contents
