Weatherproofing The Cable Connectors - Hughes HughesNet Ka-band Pointing Manual

Table of Contents

You may also see:

This message indicates that the satellite modem is

downloading necessary software. If you see this message,

you must wait until the download process completes and the

Pointing done message appears, followed by the IFL

voltage. Do not disconnect the DAPT until the IFL voltage

appears. Disconnecting the DAPT prematurely could cause a

loss of all stored data, invalidating the entire pointing process.

12. When the IFL voltage appears, disconnect the DAPT and

reconnect the receive IFL cable directly to the LNB.

13. Secure all cable connections with dielectric grease and

weatherproofing tape as shown in Figure 12.

Figure 12: Weatherproofing the cable connectors

This completes the pointing process.

Chapter 2 • Pointing the antenna

1037663-0001 Revision A

Table of Contents