Usage Of The Drain Hose - Haier HWM70-10A User Manual

How to change the direction of the drain hose
1.Dismantle the rear cover of the washing machine.
2.Lean the machine down gently with the front
surface facing the ground. Loosen the eight
screws by a cross screwdriver.
Back
Front
3.Put down the drain hose. Take off the drain
hose nut and the drain hose frame as indicated
in Figure 1.Take the drain hose into the cabinet
as indicated in Figure 2.
Drain hose
Drain hose nut
Drain hose frame
Figure 1

Usage of the drain hose

The drain hose shall drain smoothly
1.The height of the drain hose shall be
less than 10cm, or the drainage will not
be smooth, and cost such long time that
the machine may stop at mid way.
2.Do not ramp or press the drain hose.
3.If the drain hose is too long, cut it at mid
point. To make smooth drainage, cut the
front end of the hose slantingly.
4.Dismantle the drain outlet protecting cover at the
other side, and replace it with drain hose nut as
indicated in Figure 2.
5.Extend the drain hose from the other side. Fix the
drain hose with drain hose frame onto the cabinet
as indicated in Figure 3.
Bottom
Soft item
6.Install the drain outlet protecting cover to the other
side as indicated in Figure 4.
Install the bottom plate(method as described in page 3).
Lift up the machine gently. Then install the rear cover
of the machine.
Drain outlet protecting cover
Figure 2
Before Using
Before Using
Figure 3
4.If extra drain hose is needed, please
make separate purchase. The inner
diameter of the extra hose shall not
less than 30mm, and the length shall
not exceed 1.5m.
If the extra hose is too long, cut it
either at A or at B point.
Figure 4
Page 3