Install The Drain Hose; Usage Of The Drain Hose - Haier HLT364XXQ Service Manual

Install the drain hose

First install the drain hose hook on the parts of
outer drain hose component.
Put the drain hose clamp on the outer drain hose,
insert the outer drain hose into the joint for it, and
then clutch tightly with drain hose hoop.

Usage of the drain hose

Hang the outer drain hose on the proper place
before washing( do not use it toppled down
on the ground).
Attend that the outlet of drain hose shall be higher
than the water level in washtub to avoid siphon
phenomenon.
Connect the water inlet hoses
1. Attach the water inlet hoses to the hot water faucet and the cold water
faucet. Using pliers, tighten the coupling. ( As figure 1)
2. Run water through both faucets and inlet hoses, into a bucket or laundry tub, to get
rid of particles in the water lines that might clog the inlet valves screens.
3. Attach the hose connected with hot water faucet to the HOT water inlet valve(sign
with "H'). Attach the hose connected with cold water faucet to the COLD water
valve(sign with C ). ( As figure 2)
NOTE: Do not over-tighten.
4. Check for leaks
(1). Swing the water inlet hose gently to confirm if it is suitable.
(2). Turn on the water faucets and check for leaks. A small amount of water might
enter the washers. You will drain this later.
INSTALLATION AND ACCESSORY PARTS
Outer drain hose
component
Figure 1
H
C
Figure 2
Drain hose neck
Drain hose hoop
Drain hose joint
1.0m<h<1.5m