PCchips M902 Series User Manual page 32

Mainboard User's Manual
Quick Boot
1 st Boot Device
2 nd Boot Device
3 rd Boot Device
Try Other Boot
Device
S.M.A.R.T. for
Hard Disks
Floppy Drive
Swap
Floppy Drive
Seek
PS/2 Mouse
Support
Password Check
L2 Cache
System BIOS
Cacheable
SDRAM Timing
By SPD
28
If you enable this item, the system starts
up more quickly be elimination some of
the power on test routines.
Use these items to determine the device
order the computer uses to look for an
operating system to load at start-up time.
If you enable this item, the system will
also search for other boot devices if it
fails to find an operating system from the
first two locations.
Enable this item if any IDE hard disks
support the S.M.A.R.T. (Self-
Monitoring, Analysis and Reporting
Technology) feature.
If you have two diskette drives installed
and you enable this item, drive A
becomes drive B and drive B becomes
drive A.
If you enable this item, your system will
check all floppy disk drives at start up.
Disable this item unless you are using an
old 360KB drive.
Enable this item if you plan to use a PS/2
mouse.
If you have entered a password for the
system, use this item to determine, if the
password is required to enter the Setup
Utility (Setup) or required both at start-
up and to enter the Setup Utility
(Always).
Leave these items enabled since all the
processors that can be installed on this
board have internal L2 cache memory.
If you enable this item, a segment of the
system BIOS will be copied to main
memory for faster execution.
This item allows you to enable or disable
the SDRAM timing defined by the Serial
Presence Detect electrical.