NEC N8800-184F Maintenance Manual page 92

Chapter 2 Configuring and Upgrading the System
●
As long as there are no directions from maintenance personnel, ft peculiar service on ftSys
Management Appliance or an ESXi host is not stopped, or a starting setup is not changed.
●
Use only the root user to run administrative commands in the appliance. Avoid creating additional
administrative users in the appliance. The default root password is "ftServer" and changing the
password is recommended from the security viewpoint.
●
To avoid directly logging in to ftSys Management Appliance with the root user from security viewpoint,
log in to ftSys Management Appliance with the ftadmin user, and then, gain root privileges by the su
command before running the administrative commands. The default ftadmin password is "ftadmin" and
changing the password is recommended as well as that of the root user.
●
Avoid deploying your own scripts and third-party agents in the ftSys Management Appliance.
●
Avoid manually updating the CentOS software or manually adding and removing RPM software
packages in the ftSys Management Appliance.
●
ftSys Management Appliance is monitored by the ESXi host, and even if it stops, it is automatically
restarted.
●
The duplicated state continues even when ftSys Management Appliance stops. However, when a
module is isolated and duplication ends while ftSys Management Appliance is stopped, the module is
not embedded again while ftSys Management Appliance is stopped.
●
When your ft Server is included in the VMware vSphere HA cluster, set "VM restart priority" of ftSys
Management Appliance to other than "disable". When it is set to "disable", the ft Server may not be
duplicated properly.
92
Express5800/R320d-E4, R320d-M4 Maintenance Guide (VMware 5.5)
1. ftSys Management Appliance