Deck Height - MacDon M150 2009 Setup Instruction

To adjust deck height:
The deck should never touch the ground or
excessive wear could occur to some deck
components. If the deck is too low to the ground,
raise it as follows:
Lower linkage
cylinder.
Move bottom pivot pin to lower position
(R).
This will raise the front of the deck
approximately 100 mm (4 inches).
Draper tracking:
Draper tracking needs to be checked when the
draper is first run-up otherwise damage to the
draper can occur. See Draper Adjustment in the
Maintenance/Service section on how to adjust
the tracking.
Form 169216
OPERATION
by fully extending
17
R
January 2009