Troubleshooting - Polaris RANGER 2019 Owner's Manual

Table of Contents

Advertisement

TROUBLESHOOTING

DRIVE BELT WEAR/BURN
POSSIBLE CAUSE
Driving onto a pickup or tall
trailer in high range
Starting out going up a steep
incline
Driving at low RPM or ground
speed 5–11 km/h (3-7 MPH)
Insufficient warm-up at low
ambient temperatures
Slow/easy clutch engagement
Towing/pushing at low RPM/
low ground speed
Utility use/plowing
Stuck in mud or snow
Climbing over large objects
from a stopped position
Belt slippage from water or
snow ingestion into the PVT
system
Clutch malfunction
Poor engine performance
Slippage from failure to warm
up belt
Wrong or missing belt
Improper break-in
Downloaded from
ManualsNet.com
Use low range during loading.
Use low range. See warnings on page 81.
Drive at a higher speed or use low range more frequently.
Warm the engine at least 5 minutes. With the transmission in
neutral, advance the throttle to about 1/8 throttle in short bursts, 5
to 7 times. The belt will become more flexible and prevent belt
burning.
Use the throttle quickly and effectively.
Use low range only.
Use low range only.
Shift the transmission to low range and carefully use fast,
aggressive throttle application to engage clutch.
WARNING: Excessive throttle may cause loss of control and
vehicle rollover.
Shift the transmission to low range and carefully use fast, brief,
aggressive throttle application to engage clutch.
WARNING: Excessive throttle may cause loss of control and
vehicle rollover.
Dry out the PVT (see the PVT System Drying section for details).
Prevent water from entering the PVT intake duct. See Intake Pre-
Filters for more information. Inspect clutch seals for damage if
repeated leaking occurs.
Your dealer can assist.
Check for fouled plug or foreign material in gas tank or fuel lines.
Your POLARIS dealer can assist.
Always warm up the belt by operating below 48 km/h for 1.6 km
(30 mph for one mile). Warm up for 8 km (5 miles) or more when
temperature is below freezing.
Install the recommended belt.
Always break in a new belt and/or clutch.
search engine
TROUBLESHOOTING
SOLUTION
161

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents