Table of Contents
Advertisement
MCAC-UTSM-201406
Install the unit where it is convenient for pipe connection and electric connection.
The indoor unit must be installed 2.3 above floor.
The appliance shall not be installed in the laundry.
An all-pole disconnection switch having a contact separation of at least 3mm in all poles should
be connected in fixed wiring.
2. Installation of Duct Type Indoor Units
2.1 Installating indoor units
As the following picture, when install the indoor unit, select the enough solid and level site
with enough space for installation and maintance.
The inspection orifice should be enough larger to repair and maintenance the unit.
Ensure that the minimum drain gradient is over 1/100.
Use Ф10 or bigger screws. The screw material is high-quality carbon steel whose surface is
zinc plated or undergoes other anti-rust treatment, or stainless steel.
Fix the pendant bolts firmly and reliably in light of the specifice situsation.
The pendant bolt hole figure is as following picture.
Midea R410A Full DC Inverter Split Type Series Technical Manual
(Unit: mm)
24
Advertisement
Chapters
Table of Contents
