Midea MHC-96HWD1N1 Technical Manual page 77

MCAC-UTSM-201406
HEATING mode, the most comfortable settings are 28
※ Push the FAN SPEED to select the FAN mode of AUTO, HIGH, MED or LOW.
※ Push the ON/OFF button. The operation lamp lights and the air conditioner start to operate
per your settings. Push the ON/OFF button again to stop this unit operation.
Notes:
The FAN ONLY mode cannot be used to control the temperature. While in this mode, only steps1、3 and
4 may be performed.
4) DRY Operation
※ Push the MODE button to select DRY.
※ Push the TEMP button to set the desired temperature from 21
※ Push the ON/OFF button. The operation lamp lights and the air conditioner start to operate
in the DRY mode. Push the ON/OFF button again to stop this unit operation.
Notes:
Due to the difference of the set temperature of the unit and the actual indoor temperature, the Air
Conditioner when in DRY mode will automatically operate many times without running the COOL and
FAN mode.
5) TIMER Operation
Push TIMER button to set the unit what time turn on or off.
a. To set the STARTING time.
※ Push the CANCEL button to cancel any former settings.
※ Push the TIMER button. The remote controller will show the TIMER and the signal "h" is
shown on the display panel. The control is now ready to reset the TIMER ON to start the
operation.
※ Push the TEMP button ( ▲ or ▼) to set desired unit START time.
※ After setting the TIMER there will be a one-half second delay before the remote controller
transmits the signal to the Air Conditioner. Then, after approximately another 2 seconds, the
set temperature will re-appear on the digital display.
b. To set the STOPPING time.
※ Press the CANCEL button to cancel any former settings.
Midea R410A Full DC Inverter Split Type Series Technical Manual
or below.
° C
to 28 .
° C ° C
76