Midea MHC-96HWD1N1 Technical Manual page 86

Midea R410A Full DC Inverter Split Type Series Technical Manual

Wiring principle sketch:

Wiring figure:
Connect two terminals of embedded 4-core shielding wire with the switching wires of wired
controller and signal receiving board. Make sure the sequence of 4 terminals (A, B, C and D)
should correspond to the wire sequence of signal switching wires (A, B, C and D).
If the embedded 4-core shielding wire cannot go through the wired controller, it can use
signal switching for connection; make sure the wires are reliable and firm.
The tightening torque range of screw is: 0.8~1.2N· m (8~12kgf· cm).
85
MCAC-UTSM-201406