Installation And Uninstall; Notes Of Installation; Unit Installation - Hyundai CRMD 7759 B Instruction Manual

INSTALLATION AND UNINSTALL

Notes of installation

1) Before installation, please make sure
proper connections are conducted
and the unit operates normally. Improper
connection may result in damage to the
unit.
2) Use only accessor ies designed and
manufactured for this unit and other
unauthorized accessories may result in
damage to the unit.
3) Before installation, please fasten all power
cables.
4) DO NOT install the unit in the place
where close to hot area to prevent damage
to electrical components such as the laser
head.
5) Install the unit horizontally. Installing the
unit more than 30 degree vertically may
result in worse performance.
6) To prevent electric spark, connect the
positive pole first and then the negative
pole.
7) DO NOT block the cooling fan exit to
ensure sufficient heating dissipation of this
unit, or it may result in damage to this unit.

Unit Installation

Method A
1) Insert mounting bracket into dash board,
choose appropriate mounting tab
according to the gap width, bending the
mounting tab outwards with a screwdriver
to fix the mounting bracket in place.
2) Use 2 pieces of M5×5 cone shaped screw
to fix two assemble bars on both sides of
the unit (see picture 1)
(Picture 1)
3) Screw in 1 piece of M5×24 to the hole of
the unit back and put on a rubber sheath
over the screw.(see picture 2)
(Picture 2)
4) Insert the unit into the bracket, fasten
the M4×6 screw to the fireproofing board
available at the back of the dashboard,
and use 4 pieces of M2×2 screw to lock
the assemble bars and the mounting brac-
ket in position.
Note:
According to the depth of the opening, use
different length of assemble bar accordingly.
If the opening is too shallow, the monitor may
be extended out 10mm from the dashboard.
Method B
1) Insert this unit directly to the opening of the
dashboard.
2) Place M4×3, M5×5 cylindrical screw or
M5×5 cone shaped screw through the
holes of the mounting frame located inside
the opening to holes of the unit and fasten
the screws to left & right.
EN - 105
EN