Connector Type; Figure 6-3. Selecting The Connector Type - ADTRAN DSU III ARdc User Manual

Chapter 6. Configuring DTE Options

Connector Type

The CONNECTOR TYPE option is used to specify which of the primary
channel connectors is used to connect to the DTE. Figure 6-3 shows the
menu path used to set the connector type. The factory default setting is
V.35. There are no AT commands available to set the connector type.
1=LOCAL
3=CONFIG
2=REMOTE
6-4
1=NETWORK OPT.
2=DTE OPTIONS
ENTER ADDRESS
3=TEST OPTIONS
4=DIAL OPTIONS
5=MANUAL COMMAND

Figure 6-3. Selecting the Connector Type

DSU III ARdc User Manual
1=DTE RATE
1=EIA-232
2=CONNECTOR TYPE 2=V.35
3=DATA FORMAT
4=DTE CMD OPTION
5=TRANSMIT CLOCK
6=CS OPTIONS
7=ANTI-STREAM
8=CD OPTIONS
9=TR OPTIONS
A=SR OPTIONS
61200270L1-1