Fuse; Antenna Interface (N-Type Connector); At-A-Glance Specifications - ADTRAN 12804108L1A System Manual

Section 3 Engineering Guidelines
PIN
1
2

Fuse

The fuse holder, accessible from the rear panel of the TRACER 4108/4208, accepts a generic 2 A, 250 V,
2-inch slow-blo fuse.

Antenna Interface (N-Type connector)

The interface (N-Type connector) connects to the customer-supplied antenna using standard
ANTENNA
antenna feedline cable. When determining the cable specifications for your application, refer to Section 2,
Microwave Path Engineering Basics (System Losses (L) on page 18) for a discussion on cable length and
loss factors.
5.

AT-A-GLANCE SPECIFICATIONS

The following is a list of specifications for the TRACER 4108/4208 system.
Hardware
Transmitter
Output Power
Frequency Range
Receiver
Receive Level, Minimum
Receive Level, Maximum
Receive Level, Nominal
Frequency Plan
Plan A
32
Table 8. DC Power Connector Pinout
NAME + Voltage
- Ground (GND)
+ + Voltage
Table 9. At-A-Glance Specifications
Description
Channel
© 2003 ADTRAN, Inc.
+20 dBm, max
2400 to 2483.5 MHz (TRACER 4108)
5725 to 5850 MHz (TRACER 4208)
TRACER 4108
-90 dBm @ 8xT1, -93 dBm @ 4xT1, -97 dBm @ 2xT1
TRACER 4208
-85 dBm @ 8xT1, -89 dBm @ 4xT1, -92 dBm @ 2xT1
-30 dBm
-55 dBm
Plan
Tx 2.416 GHz, Rx 2.456 GHz (TRACER 4108)
1
Tx 5.742 GHz, Rx 5.822 GHz (TRACER 4208)
Tx 2.422 GHz, Rx 2.462 GHz (TRACER 4108)
2
Tx 5.747 GHz, Rx 5.827 GHz (TRACER 4208)
Tx 2.428 GHz, Rx 2.468 GHz (TRACER 4108)
3
Tx 5.753 GHz, Rx 5.833 GHz (TRACER 4208)
TRACER 4108/4208 System Manual
– Voltage
– Voltage
Ground (GND)
Specification
612804208L1-1B