Chapter 6
DTE OPTIONS
The DTE OPTIONS menu is used to select the configuration parameters
that control the operation of the DSU III ARdc's DTE interface.
DTE Rate
The selectable DTE rates over a 56 or 64 kbps loop are shown in Figure 6-
1. If a slower loop rate is selected, then the DTE rate will either match the
loop rate, or it can be set to 1.2K (see Figure 6-2). The factory default set-
ting is SAME AS LOOP.
1=LOCAL
3=CONFIG
2=REMOTE
ENTER ADDRESS
Figure 6-1. DTE Rates for 56 or 64 kbps Loop Rate
The equivalent AT commands for setting the DTE rate for a 56 kbps loop
rate are shown in Table 6-1.
61200270L1-1
Configuring DTE Options
1=NETWORK OPT.
1=DTE RATE
2=CONNECTOR TYPE
3=DATA FORMAT
2=DTE OPTIONS
4=DTE CMD OPTION
5=TRANSMIT CLOCK
6=CS OPTIONS
7=ANTI-STREAM
8=CD OPTIONS
9=TR OPTIONS
3=TEST OPTIONS
A=SR OPTIONS
4=DIAL OPTIONS
5=MANUAL COMMAND
DSU III ARdc User Manual
1=2.4K
2=4.8K
3=9.6K
4=19.2K
5=38.4K
6=56K/57.6K
For 64kbps Loop
7=SAME AS LOOP
1=SCRAMBLER OFF
8=1.2K
2=SCRAMBLER ON
3=SUPPRESS LBE
6-1