Connector Type; Data Format; Dte Command Option - ADTRAN DSU IV ESP User Manual

Chapter 7. Configuring DTE Options

Connector Type

The C
primary channel connectors is used to connect to the DTE. The
factory default setting is V.35. There are no AT commands
available to set the connector type.

Data Format

The D
asynchronous mode of operation for the DTE interface. The factory
default setting is S
length of the data bytes must be selected.
Table 7-1 on page 7-3 shows the AT commands that can be used to
set the Data Format to asynchronous or synchronous.

DTE Command Option

The DTE C
or disable all modes. The available modes are AT V.25 synchronous,
and V.25 bisynchronous/asynchronous commands. See Table 7-1
on page 7-3.
7-6
T option is used to specify which of the
ONNECTOR YPE
F option is used to select either the synchronous or
ATA ORMAT
YNCHRONOUS
option is used to enable a DTE command mode
OMMAND
DSU IV ESP User Manual
. If A is chosen, the
SYNCHRONOUS
61204011L1-1