Figure 5-1. Configuration Menu Tree For Network, Dte, And Test Options - ADTRAN DSU IV ESP User Manual

1= Local
Config
2= Remote Enter Addr.

Figure 5-1. Configuration Menu Tree for Network, DTE, and Test Options

61204011L1-1
1= Network Opt. 1= Loop Rate
2= Network Addr.
3= Remote Config
4= Network Type
5= Clock Source
1= DTE Rate
2= DTE Options
2= Connector Type
3=Data Format
4= DTE CMD Option
5=Transmit Clock
6= CS Options
7= Antistream
8= CD Options
9 =TR Options - Depends on operation mode.
See Configuring DTE Options on page 7-1 for more information.
A= SR Options
1=Test Timeout
2= RDL EN/DIS
3=Test Options
3= EIA LLB EN/DIS
4= EIA RLB EN/DIS
5= DBU Answer Test
DSU IV ESP User Manual
Chapter 5. Configuration Overview
1= Auto
2= 2.4K
1= Enter Network 3= 4.8K
2= Address:00 4= 9.6K
5= 19.2K
1= Disabled 6= 38.4K
2= Enabled 7= 56K
8= 64K
1= Dedicated
2= AT&T/MCI SW56
3= US Sprint SW 56 1= Master
2= From Network
1= 2.4K
2= 4.8K
3= 9.6K
4= 19.2K
5= 38.4K 1=Scrambler Off
6= 56K/57.6K 2=Scrambler On
7= Same as Loop 3= Suppress LBE
1= EIA-232
2= V.35 1= Async 9 bits
2= Async 10 bits
1= Asynchronous 3= Async 11 bits
2= Synchronous
1= Disabled
2= AT Command Set
1=Normal 3= V.25 Sync
2= External 4= V.25 BSC/Async
3= Invert
1= Forced On
2= Follows RS
1= Timer Off 3= Follows CD
2= Time 10 Sec
3= Time 30 Sec 1= Forced On
4= Time 60 Sec 2= Normal
3= Off with LOCD
Enter Timeout (0-Off): 00 Sec
1= Disabled
2= Enabled
1= Disabled
2= Enabled
1= CS Delay Short
2= CS Delay Long
1= Forced On
2= Off OOS Only
3= Off LOCD Only
4= Off Test Only
5= Off Test + OOS
6= Off Test + LOCD
1= RDL Ignored
2= RDL Accepted
1= Disabled
2= Enabled
5-3