NOTE: Press tool should be slightly smaller than hub bore.
NOTE: Make sure the center of the hub is supported and not the outer rim of the hub, when pressing bearing out.
7. Press bushings out of hub.
8. Remove inner race of roller bearing from the housing shaft.
NOTE: This race had Loctite applied and was pressed in place. A puller will be required to remove it.
NOTE: Make sure the center of the housing is supported and not the outer drum of the housing.
Assembly Procedure (Using New Bearings and Seal)
1. Press bushings into hub side opposite flange.
NOTE: It is important to press bushings in straight.
The bushings should also be centered in the hub socket leaving relatively equal amounts of bushing sticking out of the
hub on each side.
A suggested simple tool for pressing in bushing to hub is a 1/4 in. screw x 3 in. or 4 in. long and 1/4 in. nut. Thread nut onto
screw approximately 3/4 to 1 in.
Insert threaded end of screw into bushing. Lubricate bushing by dipping in clean water only. Then press into place.
Bearing Removal
Bushing Removal
Clutch Maintenance
11-5