a.
Rotate the engine in the normal direction of rotation (counterclockwise viewed from the flywheel end) until the top
dead center timing mark for the number 3 cylinder on the flywheel lines up with the index timing mark on the starter
mounting plate.
b.
Check the rocker arms on the number 3 cylinder to see if they are loose.
c.
If the rocker arms are loose, the engine is at top dead center of the compression stroke for the number 3 cylinder.
d.
If the rocker arms are tight, the engine is at top dead center of the exhaust stroke for the number 3 cylinder. Rotate the
engine 360 degrees to place the engine at top dead center of the compression stroke for the number 3 cylinder.
8. Check and adjust both valves for the number 3 cylinder.
9. Place the engine at top dead center of the compression stroke for the number 2 cylinder.
a.
Rotate the engine in the normal direction of rotation (counterclockwise viewed from the flywheel end) until the top
dead center timing mark for the number 2 cylinder on the flywheel lines up with the index timing mark on the starter
mounting plate.
b.
Check the rocker arms on the number 2 cylinder to see if they are loose.
c.
If the rocker arms are loose, the engine is at top dead center of the compression stroke for the number 2 cylinder.
d.
If the rocker arms are tight, the engine is at top dead center of the exhaust stroke for the number 2 cylinder. Rotate the
engine 360 degrees to place the engine at top dead center of the compression stroke for the number 2 cylinder.
10. Check and adjust both valves for the number 2 cylinder.
11. Replace the cylinder head cover.
Engine Maintenance
9-31