Thermo King T-500R Maintenance Manual page 173

1. Bracket - engine (upper rear)
2. Bracket - engine (compressor side)
3. Bracket - engine (door side)
Screw - plate & bracket (socket head)
Washer - belleville
Sealer - thread
4. Screw - mount
5. Washer - special
6. Mount - vibration
7. Nut
8. Screw - chain
UT-SERIES RESTRAINING MOUNT ADJUSTMENT
Install belts and remove slack. After belt tension has been set (no slack). Check seating in pulleys. Then proceed to tighten
locknut (#2) to compress the mount until the top of mount is in the same plane as the gauge brackets (#20). Use straight edge.to
verify. Next, re-tighten belts using TK Gauge (P/N 204-427). Set belt tension to a reading of 75 ± 5. Recheck restraining mount
alignment using a straight edge.
1. Eye Bolt
2. Locknut (3/8 in.)
3. Belleville Washer (3/8 in.)
4. Vibration Mount
5. Screw
6. Flatwasher
7. Nyloc Nut
8. Screw (3/8 in. SS)
9. NOTE: Always install chain on indented side
of eye bolt.
10. 3-Link Chain
T-Series Engine Mounting Components for 2 Cylinder Engine
UT-Series Chain/Restraining Mount
Engine Maintenance
9. Washer - belleville
10. Flatwasher
11. Nut
12. Chain
13. Bolt - eye
14. Bracket - snubber
15. Spacer - spring
16. Washer - special
17. Nut
18 Plate - bearing
Rivet - plate
11. Stud
12. Locknut (HH)
13. Flatwasher (3/8 Galv.)
14. See Note 18.
15. Locknut (HH)
16. This End Through Existing Hole In Engine Flange
17. Locknut (HH)
18. NOTE: Do not torque nuts to the normal
3/8 torque specification. This would cause
unnecessary distortion of the flatwashers. A
snug fit is all that is required.
19. Flatwasher (3/8 Galv.)
20. Gauge Bracket
Install chain on
"Depressed" side
of eye bolt.
9-35