Requirements For Operating The Wrs 200; Fitting The Adapter To The Vehicle; Fitting And Connecting The Wrs 200; Precommissioning - Kärcher WRS 200 Manual

Requirements for operating the WRS 200

A suitably large water tank should be available in order to use the
WRS 200.
The water tank must be safely fastened to the rear of the vehicle.
Attention must be paid to the maximum permissible weight and
permissible axle loads of the vehicle when selecting the water
tank.

Fitting the adapter to the vehicle

The adapter with coupling triangle is attached to the rear of the
vehicle for mounting the WRS 200.
Adapter with coupling triangle
1
Bolts with spring pins (2x)
2
Screws (2x)
3
1. Slide the adapter into the mounting frame.
2. Secure the adapter with 2 bolts and spring pins.
3. Tighten the screws to prevent play between the frame and
adapter.

Fitting and connecting the WRS 200

The WRS 200 is attached to the adapter with coupling triangle
and secured by a screw.
We recommend using the help of a second person for attaching
the device.
WRS 200
1
Lift truck
2
Adapter with coupling triangle
3
1. Use the lift truck to position the WRS 200 approximately 30 cm
in front of the adapter and then lift it until it is positioned above
the adapter.
Hydraulic hoses
1
Water connection
2
Cable with plug
3
2. Connect the hydraulic hoses to the WRS 200 and insert into
the PTO hydraulic connection on the vehicle.
3. Connect up the water hose.
4. Insert the cable with plug into the trailer socket.
Screw (retainer)
1
WRS 200
2
5. Slowly move the WRS 200 forwards as far as it will go and
then lower it into the adapter coupling triangle.
6. Secure the WRS 200 with the screw.
WARNING
Danger of injury
Check that the battery, accessories, supply lines, water filter and
connections are in a correct condition before using the device.
Only use the device when it is in a correct condition.
1. Check the filling level in the fuel canister and fill if necessary.
2. Check the filling level in the detergent container and fill with
RM 110 if necessary.
3. Check the filling level in the water tank and fill if necessary.
DANGER
Explosion hazard due to overflowing fuel
Take care ensure that no fuel spills onto hot surfaces when refu-
elling.
DANGER
Explosion hazard due to smoking and naked flames
Ensure strict prohibition of smoking and open flames during the
refuelling procedure.
WARNING
Health risk from inhaled vapours
Do not refuel in confined spaces.
English

Precommissioning

Refuelling
19