Startup - Kärcher WRS 200 Manual

ATTENTION
Risk of damage due to incorrect fuel
Refuel with Diesel only.
ATTENTION
Risk of damage due to the fuel pump running dry
Check the filling level of the fuel canister regularly, refuel in time
as necessary.
Note
Refill with fuel only when the canister is detached. Use only orig-
inal canisters.
Left-hand door
1
Fuel canister
2
Retaining strap
3
Tank cap with fuel lines
4
Detergent container
5
1. Release the rubber latch on the left-hand door and open the
door.
2. Release the retaining strap from the canister.
3. Open the tank cap and allow any fuel to drip off before remov-
ing the cap.
4. Fasten the tank cap with fuel lines open at the top.
5. Remove the canister.
6. Refill with Diesel.
7. Insert the canister and secure with the retaining strap.
8. Fit the tank cap with fuel lines.
9. Close the tank cap.
10.Wipe off any spilt fuel.
11.Close the left-hand door and secure with the rubber latch.
Filling the detergent container
The RM 110 liquid softener is a highly effective agent for prevent-
ing calcification of the heating coil when operating with hard wa-
ter. The supply line is drip-fed with the desired dosage from the
detergent container.
The dosage is set at the factory for water hardnesses of up to ap-
prox. 30 °dH. The dosing valve can be adjusted if necessary. See
chapter "Adjusting dosage".
ATTENTION
Health risk
Observe the safety and handling instructions for handling RM
110.
20
Detergent container
1
Cover
2
1. Open the lid of the detergent container.
2. Add RM 110 to the detergent container, do not overfill.
3. Close the cover.
The dosage is set at the factory for water hardnesses of up to ap-
prox. 30 °dH (position between 1 and 2).
Cover
1
Detergent dosing pump
2
Position 1
3
Note
Up to 10 °dH
Position 2
4
Note
Up to 55 °dH
1. Remove the cover.
2. Adjust position 1 to 2 for the desired degree of water hardness.
Higher positions are irrelevant because these degrees of hard-
ness do not occur.
3. Attach the cover.
WARNING
Risk of injury from high-pressure jet or electric shock.
Check that the device, accessories, supply lines and connections
are in a correct condition before using the device.
Only use the device when it is in a correct condition.
Connect the high-pressure hose and high-pressure
The high-pressure hose is stored in a storage compartment be-
hind the right-hand door.
The high-pressure gun with spray lance is located in holders at-
tached to the left front side of the WRS 200.
English
Adjusting the dosage

Startup

gun