Name Of Parts; Installation Procedure - Haier 1U24GS4ERA Installation Manual

Name of Parts

1U24GS1ERA 1U28GS2ERA(S)
Air inlet
Air outlet
Compressor
(Inside of unit)
1U48LS1ERA(S) 1U48LS1ERB(S) 1U48LS1EAB(S)
Air inlet
Air outlet
Compressor
(Inside of unit)

Installation Procedure

1. Selection of the place of installation
Select the place of installation satisfying the following conditions and, at the same time, obtain a consent from the client or
user.
Place where air circulates.
Place free from heat radiation from other heat sources.
Place where drain water may be discharged.
Place where noise and hot air may not disturb the neighborhood.
Place where there is not heavy snowfall in the winter time.
Place where obstacles do not exist near the air inlet and air outlet .
Place where the air outlet may not be exposed to a strong wind.
Place surrounded at four sides are not suitable for installation. A 1m or more of overhead space is needed for the unit.
Avoid mounting guide-louvers to the place where short-circuit is a possibility.
When installing several units, secure sufficient suction space to avoid short circuiting.
Open space requirement around the unit
Air inlet
L2
Air outlet
L3
500
(Servicing
space)
L1
1U28HS1ERA(S) 1U36HS1ERA(S)
Air inlet
Air outlet
Compressor
(Inside of unit)
1U48IS1EAB(S) 1U48IS1ERB(S) 1U60IS1ERA(S)
1U60IS1ERB(S) 1U60IS1EAB(S) 1U60IS2EAB(S)
1U60IS2ERB(S)
Air inlet
Air outlet
Compressor
(Inside of unit)
Distance
Case I Case II
open open
L1
L2 300 mm 300 mm
L3 150 mm 300 mm
10
Installation of Outdoor Unit
Case III
500 mm
open
150 mm