Ethernet Port Connector - Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Manual

Appendix B Connector Pin Assignments
Table B-3
RJ-45
Pin
5
6
7
8
Table B-4
RJ-45 Pin
End 1
1
2
3
4
5
6
7
8

Ethernet Port Connector

The CDEs come with an integrated dual-port Ethernet controller. This controller provides an interface
for connecting to 10-Mbps, 100-Mbps, or 1000-Mbps networks and provides full-duplex (FDX)
capability, which enables simultaneous transmission and reception of data on the Ethernet LAN.
To access the Ethernet port, connect a Category 3, 4, or 5 unshielded twisted-pair (UTP) cable to the
RJ-45 connector on the back of the device.
Note The 100BASE-TX/1000BASE-TX Ethernet standard requires that the cabling in the network be
Category 5 or higher.
OL-13478-03
Ethernet Connector Pin Assignments for T568B (continued)
Wire Color Wire Diagram
(T568B) (T568B)
White/Blue
Green
White/Brown
Brown
RJ-45 Crossover Cable Pin Assignments for T568B
Wire Color Diagram End 1
White/Orange
Orange
White/Green
Blue
White/Blue
Green
White/Brown
Brown
Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Guide
Ethernet Connector Pin Assignments
10BASE-T 1000BASE-T
100BASE-T Signal
Unused BI_DC–
Receive– BI_DB–
Unused BI_DD+
Unused BI_DD–
RJ-45 Pin End 2
3
6
1
7
8
2
4
5
B-3