Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Manual page 51

Chapter 3 Installing the Content Delivery Engines
Install a disk drive by performing the following steps:
Warning
Power off the CDE before removing or installing a disk drive.
Step 1
To access the disk drives on a CDE200, CDE300, and CDE400, you must first remove the front cover by
Step 2
turning the keys on the left and right sides of the cover and removing it from the CDE (see 1 and 2 in
Figure
Figure 3-10
Unlock the latch by pressing the safety lock button on the front of the latch (see
Step 3
Unlatch the disk drive tray from the locking clip and swing open the main latch (see
Step 4
Step 5 Carefully pull the disk drive out of its drive tray slot.
Step 6 Insert a new disk drive into the drive tray slot and make sure it is properly seated.
Step 7 Close the latch completely and lock it in place by pressing the safety lock button.
OL-13478-03
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not
directly touch the backplane with your hand or any metal tool, or you could shock yourself.
Statement 94
3-10).
CDE200 Front Cover
1
1 2
Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Guide
Installing the CDEs
2
Figure 3-11).
Figure 3-11).
3-11