Initially Configuring A Cde; Assigning The Primary Interface - Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Manual

Content delivery engine
Table of Contents

Advertisement

Initially Configuring a CDE

Note
Step 2
Choose Option 3 to install the flash cookie.
Choose Option 5 to install the flash image from the CD-ROM drive.
Step 3
Choose Sub-option 2 and enter Y to confirm and proceed with the flash write.
Step 4
Choose Option 7 to wipe out the disks and install the .bin image. Enter Y to confirm and wipe out all
Step 5
disks. You should see something like this:
Step 6
Eject the CD from the CD-ROM drive, disconnect the CD-ROM drive from the CDE, and choose Option
8 to exit and reboot. Press Y and Enter to confirm the reboot request.
The system boots from the IDE compact flash drive with the data installed from the CD. All prior data
is removed and the original system remains unaffected.
Caution

Initially Configuring a CDE

This section provides the steps to perform the initial software configuration after a CDE has been loaded
with a CDS software image for the first time. The initial configuration must be done on all CDEs (SEs,
SRs, and CDSM) in a network.

Assigning the Primary Interface

The CDE must be configured with a primary interface that acts as the management interface for the CDE.
Any interface in the CDE can be configured as the primary interface. Interface GigabitEthernet 1/0 is
chosen by default to be the primary interface.
Enter the following commands to assign a primary interface:
CDE# configure
CDE(config)# primary-interface GigabitEthernet 1/0
Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Guide
4-14
This step is not necessary if the IDE compact flash drive has been previously manufactured. The
system produces an error; ignore the error and proceed.
Successfully installed product image.
MODEL: CDE200
FLASH: found, directory validated
COOKIE: valid
IMAGE: 2.0.0.320
FLASHDEV: /dev/hdc
Be sure to disconnect the CD-ROM drive before rebooting the system or the system will not
boot with the normal image.
Chapter 4
Installing the Internet Streamer CDS Software and Initially Configuring a CDE
OL-13478-03

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents