Running The Bios Setup Utility For The Cde200 - Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Manual

Chapter 4 Installing the Internet Streamer CDS Software and Initially Configuring a CDE

Running the BIOS Setup Utility for the CDE200

Perform the following steps to run the BIOS setup utility for the CDE200:
Ensure that the CDE200 is powered off.
Step 1
Step 2 Attach the USB CD-ROM drive to any available USB port at the rear of the CDE200 (see
Step 3 Power on the USB CD-ROM drive.
Step 4 Power on the CDE200 and wait for the initial BIOS screen to appear.
Note Step 5
changed for the second and subsequent installations or recovery.
Step 5 To enter the BIOS Setup menu, press Delete as instructed at the bottom of the BIOS screen. The Main
menu appears (see
Figure 4-11
Tip If you are viewing the initial BIOS screen through a remote terminal server, Ctrl-Backspace functions
the same as the Delete key.
Step 6 Use the arrow keys to navigate to the Advanced menu and press Enter. The Advanced menu appears (see
Figure
OL-13478-03
through Step 12 are required only for the initial installation. The BIOS setup does not need to be
Figure 4-11).
Main Menu
4-12).
Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Guide
Running the BIOS Setup Utility
Figure 1-4).
4-9