Cde200 - Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Manual

Specifications

CDE200

Dimensions (H x W x D)
Weight
Content Storage Capacity
Management Interface
Ingest Interface
Stream Interfaces
Transport
Memory
Processor
Protocols
Controllers
Operating System
Operating System Disk
Cable length
Performance Monitoring
Power
Fan Assembly
Operating Temperature
Humidity
Short Term Humidity
Altitude
1. The power supplies for the CDE200 ISV server has not been investigated for hot-swapping.
Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Guide
C-2
3.50 (2U) × 17.50 × 28.50 in. (8.90 × 44.45 × 72.39 cm)
Chassis fully configured (all slots filled): 53.5 lb. (24.27 kg)
12 Serial-ATA 320, 400, or 500 GB hard drives
1 Gigabit Ethernet interface
1 Gigabit Ethernet interface
3 Gigabit Ethernet interfaces
High Definition MPEG-2 and Advanced Codec; Network PVR is fully
supported
8 Gigabytes RAM
Two Dual Xeon @ 3.2 GHz (or above)
IP, SNMP, FTP, Gigabit Ethernet, SSH, FSI, DSM-CC, LSCP, RTSP
Marvell Serial-ATA
Red Hat 7.3 distribution supporting Linux kernel 2.4.19
Two 60– GB small form-factor IDE hard drives
Twisted Pair: Maximum of 330 ft (100 m) using Category 5E or higher,
4 pair
Fiber-Optic SX multimode: 1640 ft (500 m) maximum (50/125 mm),
902 ft (275 m) maximum (62.5/125 mm)
Integrate with both the Tandberg and C-COR back office suite
500 W (110 and 220 VAC or –48 VDC) redundant, hot-swappable
Redundant with operation alarm monitored by system
32 to 122°F (0 to 50°C)
5 to 95% noncondensing
5 to 98% (96 hours)
–197 to 13120 ft (–60 to 4000 m)
Appendix C CDEs with Serverworks Chipset
1
OL-13478-03