Assembly; Before You Do Assembly; To Connect The Lower Handle; To Connect The Upper Handle - Gardena PowerMax Li-40/32 Operating Instructions Manual

Check the working area for hidden cables.
Do not use for pond care or close to water.
Personal safety
WARNING!
• Risk of suffocation
• Small parts can be easily swallowed.
There is also a risk that the polybag can
suffocate toddlers.
• Keep toddlers away when you assemble
the product.
Do not use in explosive atmosphere.
Never operate the product when you are tired, ill or under
the influence of alcohol, drugs or medicine.
Do not overload the mower.
Use gloves, wear slip resistant shoes and wear eye
protection.

Before you do assembly

WARNING!
• Risk of physical injury!
• Cut injury when the blade turns or the
product starts accidentally.
• Wait for the blade to stop, remove the
safety key and use gloves before you do

assembly.

To connect the lower handle

2
3
1. Put the lower handle (1) in the product.
Make sure that the handles are fully in place and
the handle hole is inline with the threaded hole.
2. Put the washer (2) on the wing screw (3).
22 - 001 - 05.10.2016
Do not use under wet conditions.
Do not disassemble the product further than the delivery
status.
Only start the mower with an upright standed handle.
Do not use the start levers alternately.
Use the handles carefully.
Safety Cut-Out
The engine is protected by a Safety Cut-Out which is
activated when the blade becomes jammed or if the
engine is overloaded. When this occurs, stop and
disconnect the product from the mains. The Safety Cut-
Out will only reset when you release the start/stop lever.
Clear any obstruction and wait for a few minutes for the
Safety Cut-Out to reset before you continue to use the
product.
Assembly
3. Put the wing screw (3) in the threaded hole in the
product.
4. Tighten the wing screw (3).

To connect the upper handle

1
2
5
3
1. Put the upper handle (4) on the lower handle (1).
2. Push the screw (5) through the hole.
3. Put the washer (2) and the wing nut (6) on the screw
(5).
4
2
6
5
1
2
Make sure that the handles are fully in place and
the handle holes are inline.
21