Assembly; Before You Do Assembly; To Connect The Lower Handle; To Connect The Upper Handle - Gardena 5031 D Operating Instructions Manual

Safety Cut-Out to reset before you continue to use the
product.

Before you do assembly

WARNING!
• Risk of physical injury!
• Cut injury when the blade turns or the
product starts accidentally.
• Wait for the blade to stop, disconnect the
product from the mains and use gloves
before you do assembly.

To connect the lower handle

2
1. Put both lower handles (1) in the product.
Make sure that the handles are fully in place and
the handle hole is inline with the threaded hole.
2. Put both screws (2) in the threaded holes in the
product.
3. Tighten the screws (2).
20

Assembly

To connect the upper handle

1
2
1. Insert the cable lock (15) to the upper handle (4) with
2. Put the upper handle (4) on the lower handle (1).
3. Push the screws (5) through the holes.
4. Put the washers (3) and the wing nuts (6) on the
5. Tighten the wing nuts (6).
5
4
6
5
3
1
the switch box (S).
Make sure that the handles are fully in place and
the handle holes are inline.
screws (5).
32 - 001 -