Troubleshooting; Before You Do Troubleshooting; To Replace The Blade; Troubleshooting Table - Gardena PowerMax Li-40/32 Operating Instructions Manual

2. Dispose of lithium-ion cells properly.

Before you do troubleshooting

WARNING!
• Risk of physical injury!
• Cut injury when the blade turns or the
product starts accidentally.
• Wait for the blade to stop, remove the
safety key and use gloves before you do

troubleshooting.

To replace the blade

WARNING!
• Risk of physical injury!
• Cut injury when the blade turns and it is
damaged, bent, out of balance or has
chipped edges.
• Do not use the product when the blade is
damaged, bent, out of balance or has
chipped edges.
• Do not regrind the blade.

Troubleshooting table

Problem
Engine does not start.
Engine is jammed and makes a
noise.
Loud noises, the mower is rattling. Screws on engine, its fixing or on the
Product runs unevenly or vibrates
strongly.
Lawn is not cleanly cut.
26
Troubleshooting
The GARDENA spare parts are availible from your
GARDENA dealer or from the GARDENA service.
Only use an original GARDENA blade:
GARDENA replacement blade Art. 4100
•
[5822490-01].
1. Let the blade replace by the GARDENA Service or a
specialist dealer authorised by GARDENA .
Possible Cause
Extension cable is disconnected or da-
maged.
Blade is blocked.
Blade is blocked.
Cutting height is too low.
mower chasing are loose.
Blade is damaged or the blade moun-
ting is released.
Blade is very dirty.
Blade is blunt or damaged.
Cutting height is too low.
Remedy
Connect the extension cable or if ne-
cessary replace it.
Remove the obstacle.
Remove the obstacle.
Raise the cutting height.
Have screws tightened by an authori-
sed specialist dealer or the GARDENA
Service.
Have blade tightened or replaced by
an authorised specialist dealer or the
GARDENA Service.
Clean the mower (see Maintenance). If
this does not rectify the problem, con-
tact the GARDENA Service.
Have blade replaced by the GARDENA
Service.
Raise the cutting height.
22 - 001 - 05.10.2016