Fig. 7 - EdilKamin TINY Installation, Use And Maintenance Manual

CONTINUED: TINY model series radio remote control
RESERVE WARNING
The stove is fitted with an electronic function that detects the residual quantity of pellets in the tank.
The detection system is integrated into the electronic board, allowing you to see how many hours and kg are left until
pellet exhaustion, at all times. For correct system function, it is important that the following procedure is followed during
the first ignition (by the Dealer).
1 st ignition/test by the Edilkamin authorised Dealer
Start-up must be carried out as prescribed by point 3.21 of standard UNI 10683.
This standard indicates the control operations to be carried out in situ, aimed at ascertaining correct system function.
Pellet reserve system
Before enabling the system, you need to load a sack of pellets into the tank and use the stove until the loaded fuel has
run out. This allows for a short system road test.
After this, the tank can be filled completely and the stove started up.
When running, at the time at which a whole 15 kg sack of pellets can be loaded, the display will show the word
"RESERVE" flashing.
At this point, after having poured in a sack of pellets, you need to 'inform' the memory that you have loaded 15 kg.
To do so, proceed as follows:
1. press the "M" key (for approximately 3-4 seconds) until the word "CLOCK" appears.
2. press the "+" key until the word "RESERVE" appears.
3. press the "M" key until the following screen appears,
Kg remaining in tank
then use the "+" key to take the figure (*) to the value equal to the Kg of pellets loaded (15 kg in the above example).
4. press the "M" key to confirm
5. press the key
After having completed the above procedure, after having consumed the 15 kg, the wording "RESERVE" will appear
flashing at intervals. After which the operation must be repeated, from point 1 to point 5.
EMERGENCY BUTTON
If the radio remote control fails you can access the basic functions using a red emergency button located under the outer
door, to the right (see fig 7).
Press the button once or several times to enable the desired function:
1. A STOVE OFF
by pressing the red button for 2 seconds this turns on.
2. A STOVE 54 ON
by pressing the red button for 2 seconds this turns off.
3. A STOVE 54 ON
manual mode, by pressing the red button, you go from P1 to P5.
4. A STOVE 54 ON
automatic mode, by pressing the red button, you go from 5°C to 30°C.
RADIO ANTENNA
The radio signal is received from the radio remote control via a small antenna built into the circuit board.
INSTRUCTIONS FOR USE
to exit.

fig. 7

47
Kg loaded
emergency button