During Operation - AERMEC VED Series Use And Installation Manual

IMPORTANT INFORMATION AND MAINTENANCE
WARNING: the fan coil is connected
to power supply and hydraulic circuit.
Operations performed by people
without the required technical skills
can lead to personal injury to the
operator or damage to the unit and
surrounding objects.
ONLY POWER THE FAN COIL AT 230V
~ 50Hz
Any other type of power supply could
permanently damage the fan coil.
D O N O T U S E T H E F A N C O I L
IMPROPERLY
Do not use the fan coil for animal
h u s b a n d r y a p p l i c a t i o n s
incubation).
AIR THE ROOM
Periodically air the room in which the
fan coil has been installed. This is
particularly important if the room is
occupied by many people, or if gas
appliances or sources of odours are
present.
ADJUST TEMPERATURE ADEQUATELY
The external temperature should be
adjusted in order to provide maximum
comfort to the people in the room,
especially if they are elderly, children
or sick people; avoid differences over
7°C between the outdoor temperature
and the temperature inside the room in
summer.
In summer, a temperature that is too low
causes higher electrical consumption.
CORRECTLY ADJUST THE AIR JET
Air coming out from the fan coil must
not reach people directly; in fact, even
if the air is warmer than the room
temperature, it could cause a cold
sensation and result in discomfort.
AIR FILTER REMOVAL AND REPLACEMENT
The air filter must be removed from the
fan coil for cleaning.
The cleaned or new air filter (for
replacement) must be correctly fitted
and secured in its housing in the
fancoil.
To remove the air filter:
- loosen the screws of the two filter clips
- slide the two filter retainers until they
stop
- remove the filter from its housing
PACKAGING
The fan coils are sent in standard packaging made of foam polystyrene and cardboard.
USE
Consult control panel manual for installation and use instructions.
DO NOT USE EXCESSIVELY HOT
WATER
Clean the fan coil with a soft cloth
or sponge soaked in water not over
40°C. Do not use chemical products
or solvents to clean any part of the fan
coil. Do not spray water on the outer or
inner surfaces of the fan coil (this might
cause short circuits).
CLEAN THE FILTER PERIODICALLY
Cleaning the filter frequently guarantees
enhanced operating efficiency.
Check whether the filter is very dirty: in
this case, clean it more often.
C l e a n f r e q u e n t l y ; r e m o v e t h e
( e . g .
accumulated dust with a vacuum
cleaner.
Once the filter is clean, refit it on the fan
coil following the removal instructions
but in reverse order.
SUPPLEMENTARY CLEANING
The fact that the blades of examinable
shrouds can be removed (operation
done only by adequately skilled
technicians) ensures a thorough
cleaning of the internal components,
which is particularly important when
installing the unit in crowded areas
or venues requiring high hygiene
standards.

DURING OPERATION

Always leave the filter fitted on the fan
coil during operation (otherwise dust in
the air could soil the coil surface area).
WHAT IS NORMAL
In the cooling operation, water vapour
may be present in the air delivery of the
fan coil.
In the heating operation, a slight hiss
might be heard close to the fan coil.
Sometimes the fan coil might give
off unpleasant smells due to the
To reassemble the air filter:
- insert the air filter into its housing,
- slide the two filter clips until the filter is
secured,
- tighten the screws of the two filter clips,
- make sure the filter is secured in its
housing.
accumulation of substances present
in the air of the room (clean the filter
more often, especially if the room is not
ventilated regularly).
While the unit is functioning, there
could be noises and creaks inside
the device due to the various thermal
expansions of the elements (plastic and
metal), but this does not indicate any
malfunction and does not damage the
unit unless the maximum input water
temperature is exceeded.
MALFUNCTIONING
In case of malfunction, cut off power
to the unit, then energise it again and
restart the device.
WARNING! Do not attempt to repair
the unit alone, this is extremely
dangerous!
If the problem occurs again, call the
local Aftersales Service immediately.
DO NOT TUG THE ELECTRIC CABLE
It is very dangerous to pull, tread on or
crush the electric power cable, or fix it
with nails or drawing pins.
A damaged power cable can cause short
circuits and injure people.
D O N OT O B S T R U C T T H E A I R
OUTLETS BY PLACING OBJECTS
INTO THEM
Never insert objects of any kind in the
air delivery and outlet.
This could injure people and damage
the fan.
WARNING
Avoid that the device is used by children
or incompetent persons without
appropriate supervision; also note that
the unit should not be used by children
as a game.
IVEDLJ 1107 - 4880900_01
15