Month Warranty - BEHA UNITEST Therm 200 Instruction Manual

Warranty
Power supply: ............4 x 1.5 V, IEC LR03 or via external
Current
consumption: ............approx. 5 mA (typical) or approx. 25
External power supply:
Voltage. ......................6 VDC ± 10% without potential
Current: ......................0.1 A
Power supply unit:
Socket 2: ....................Pin 2, input GND
..................................Pin 4, input + 6 V
Dimensions: ..............172 x 72 x 32 mm
Weight: ......................approx. 220 g
Protection degree: ......IP40
Hight above MSL: ...... up to 2000 m
Environment
Condition: ..................0 °C to 40 °C at max. 80 %
Storage Temperature: -20...60°C, max. 80% rel. humidity

24 month Warranty

UNITEST instruments are subject to strict quality control.
However, should the instrument function improperly during
daily use, your are protected by our 24 months warranty
(valid only with invoice). We will repair free of charge any
defects in workmanship or material, provided the instru-
ment is returned unopened and untampered with, i.e. with
undamaged warranty label. Any damage due to dropping or
incorrect handling are not covered by the warranty. If the
instrument shows failure following expiration of warranty,
our service department can offer you a quick and econom-
ical repair.
Subject to technical changes without notice !
54
power supply unit
mA (for Therm 200 with switched on
measurement point illumination)
relative humidity
(without batterie)