Calibration Interval; Technical Data - BEHA UNITEST Therm 200 Instruction Manual

6.3 Calibration Interval

We suggest a calibration interval of one year. If the instrument
is used very often or if it is used under rough conditions we
recommend shorter intervals. If the instrument is used few
times only the calibration interval can be extended on to 3
years.

7.0 Technical Data

(at 23° C ± 5 %, less then 75 % rel. humidity)
Display: ..............3
Range
-100 °C...999,9 °C
1000°...1370°
-148°F...999,9°F
1000°F...2490°F
Measurement rate:: ....ca. 1 Messungen pro Sekunde
Temperatur-
coeffizient: ..................0,2 ° in range, 0...18 °C or 28
Memory (only Therm 300)
Datalogger..................max. 1000 values
Single values ..............max. 80 values
Analogue Recorder Output:
Socket 2: ....................Pin 2, Output GND
..................................Pin 6, Output +
Scale factor/
Recorder constant: ....1 mV/°C, 0.5 mV/°F
Tolerance: ..................± (1% v.M. + 1 mV)
Dynamic range: ..........± 1300 mV
Load: ..........................> 100 kΩ
1 /
digit, digital LC-Display,
2
with symbols
Resolution
0,1°C
1°C
0,1°F
1°F
°C...40 °C
Technical Data
Accuracy
±(0,5% rdg. + 1°)
±(0,5% rdg. + 2°)
53