HP Jetdirect J7949e Administrator's Manual page 78

Table 3.4 Telnet Commands and Parameters (6 of 13)
syslog-max
syslog-priority
syslog-facility
slp-config
slp-keep-alive
mdns-config
mdns-service-name
mDNS Domain
Name
ENWW
Specifies the maximum number of syslog messages that
can be sent by the HP Jetdirect print server on a per-minute
basis. This setting allows administrators to control the log
file size. The default is 10 per minute. If it's set to zero, the
number of syslog messages is not restricted.
Controls the filtering of syslog messages sent to the syslog
server. The filter range is 0 to 8, with 0 being the most
specific and 8 the most general. Only messages that are
lower than the filter level specified (or higher in priority) are
reported. The default setting is 8, where messages of all
priorities are sent.
If 0, all syslog messages are disabled.
A code used to identify the source facility of a message (for
example, to identify the source of selected messages during
troubleshooting). By default, the HP Jetdirect print server
uses LPR as the source facility code, but local user values
of local0 through local7 can be used to isolate individual or
groups of print servers.
Enables or disables the Service Location Protocol (SLP)
operation on the print server: 0 disables, 1 (default) enables.
SLP is used by selected HP software applications (through
UDP port 427) to automate device discovery.
Specifies a time period for the print server to send multicast
packets on the network to prevent being deleted from
network device tables. Some infrastructure devices, such as
switches, may delete active devices from their device tables
due to inactivity on the network. To enable this feature, set
a value from 1 to 1440 minutes. Set 0 to disable this feature.
Enables or disables Multicast Domain Name System
(mDNS) services. 0 disables, 1 (default) enables. mDNS is
typically used on small networks for IP address and name
resolution (through UDP port 5353) where a conventional
DNS server is not available.
Specifies an alphanumeric string of up to 64 ASCII
characters assigned to this device or service. This name is
persistent and is used to resolve a particular device or
service if socket information (such as the IP address)
changes from session to session. Apple Rendezvous will
display this service. The default service name is the printer
model and the LAN Hardware (MAC) address.
(Read-only parameter) Specifies the mDNS domain name
assigned to the device, in the form <host name>.local. If a
user-specifed host name has not been assigned, the default
host name NPIxxxxxx is used, where xxxxxx are the last 6
digits of the LAN hardware (MAC) address.
TCP/IP Configuration 78