HP Jetdirect J7949e Administrator's Manual page 199

Table 9.9 Error Messages (5 of 10)
Error Code and
Message
22 UNABLE TO
CONNECT TO
SERVER
23 UNABLE TO
ATTACH TO QUEUE
24 PSERVER CLOSED
CONNECTION
25 DISCONNECTING -
SPX TIMEOUT
26 UNKNOWN NCP
RETURN CODE
27 UNEXPECTED
PSERVER DATA RCVD
28 OUT OF BUFFERS
ENWW
Description
Queue Server mode error: The HP Jetdirect print server
could not establish an NCP connection to the file server.
Make sure that the correct file servers are connected.
When multiple file servers are configured, the error is only
displayed on the configuration page if none of the file servers
were successfully connected.
A failure was detected when the HP Jetdirect print server
tried to attach to one of the queues assigned to the print
server object. This may be because no servers are allowed
to attach to this queue. There may also be a networking or
security problem. Use PCONSOLE to make sure that
servers are allowed to attach to the queue, to delete the print
server object from the list of queue servers if you want the
HP Jetdirect print server to service other queues, or to
delete the queue and create a new one (the print server
object must be added to the list of queue servers).
When the HP Jetdirect print server is configured for multiple
file servers, the error is only displayed on the configuration
page if none of the file servers made the connection.
The NetWare print server requested a termination of the
connection with the HP Jetdirect print server. No error exists
or is indicated. Make sure the NetWare print server is
running, and restart it if necessary.
The SPX connection to the print server was lost after the
connection had been made. This indicates a possible
network problem, or a problem with the print server. Make
sure all cables and routers are functioning correctly. Try
restarting the print server.
The HP Jetdirect print server encountered an unexpected
fatal error after it had successfully connected to the file
server. A wide variety of failures could produce this error
message, including a downed file server or a network
router failure.
The print server sent some data when the HP Jetdirect print
server had not given its permission to do so. This indicates
a possible print server problem, possibly a software
problem.
The HP Jetdirect print server was unable to allocate a buffer
from its internal memory. This indicates all buffers are busy
due possibly to heavy broadcast traffic or large amounts of
network traffic directed to the print server.
HP Jetdirect Configuration Page 199