Assembly; Before You Do Assembly; To Connect The Front Handle - Gardena ComfortCut 550/50 Operating Instructions Manual

• if you hit an object. Do not use your product until you
are sure that the entire product is in a safe operating
condition.
• if the product starts to vibrate abnormally. Check
immediately. Excessive vibration can cause injury.
• before passing to another person.
Only use the product between 0 – 40 °C.
Maintenance and storage
Risk of injury. Do not touch the blades.

Before you do assembly

WARNING!
• Risc of physical injury!
• Cut injury when the product starts
accidentally.
• Disconnect the product from the mains
and slid the protective cover over the
blade before you do assembly.

To connect the front handle

9
1
2
15 - 002 - 30.09.2016
• Disconnect the product from the mains and slid
the protective cover over the blade when you
finish or interrupt the work.
Keep all nuts, bolts and screws secure to be sure the
product is in safe working condition.
If the product got hot while operation, let it cool down
before storage.

Assembly

1. Push the front handle (1) into the slot in the product.
Make sure that the front handle (1) is fully in place
and the handle hole is inline up with the threaded
hole.
2. Put both screws (2) in the threaded hole in the
product.
Do not push the start button (9) while you doing
this.
3. Tighten both screws (2) with a screwdriver.
4. Make sure that the screws (2) are fully tightened and
the start button (9) can be fully pushed.
2
17