Connecting Power - Compaq Netelligent 3024 User Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-2 Setting Up the Repeater
The electrical requirements for the repeater are as follows:
* The repeater's power supply automatically adjusts to the incoming power.
Spatial Requirements
The repeater's dimensions are: 1.75 x 17.00 x 11.65 inches (4.44 x 43.18 x
29.6 cm) (HxWxD). When you set the repeater on a level surface, allow at
least 2 inches (5.1 centimeters) on each side of the repeater for proper air
circulation. Leave at least 2 feet in front of the repeater to allow access for
connections.

Connecting Power

Follow these steps to connect the repeater to power:
1. Plug the power cord into the power connector on the back of the
WARNING: The power outlet must be a non-switched, 3-pronged,
grounded outlet. Do not use a 3-to-2 pronged adapter at the outlet; using
this type of adapter may result in electrical shock and/or damage to the
repeater. Using the 3-to-2 adapter will also void the repeater's warranty.
Setting
Voltage
Frequency
Current
repeater. The lip on the power connector faces the top of the repeater.
Table 3-1
Electrical Requirements
Requirements
100 to 130 VAC*
60 to 50 Hz
0.21 to 0.1 Amps maximum